The Boat

Katla is a 26ft Wooden Gaff Cutter built by Martin Lund in 2006 of the Wynfall design by Mark Smaalders.

She is
Carvel built of Mahogany planks over sawn Pine frames. The planks are fastened with Stainless Steel (316) screws and the frames are glued and fastened using wooden pegs and Galvanised bolts. Before painting, all wood was treated with a mixture of Turpentine, Pine Oil and Cuprinol.

The deck is Marine Plywood epoxy laminated and covered with chopped strand mat in epoxy resin. The Spar is of Siberian Larch. The rudder is transom hung on Stainless Steel (316) pintles.

The ballast keel is a Stainless Steel (316) box of 6mm sides and bottom, which has lead ingots in it. The lead is then laid in poliester resin inside. Five Stainless Steel (316) tubes are welded inside vertically through the keel box, where the keel bolts go through, meaning the box is completely sealed from seawater. There are 5 Stainless Steel (316) keelbolts to carry 1.5 tonnes. It is a massively strong construction.

There are no through hull fittings and a water tight bulkhead under the cockpit.

The broker described her as: 'A sturdy and salty little lady. Which will appeal to traditionalists on a budget'.

There is no inboard engine, no toilet, no electronics, and traditional (Block & Tackle) rigging (no winches).

LOA: 26' - 5"
LWL: 23' - 10"
BEAM: 8' - 10"
DRAFT: 3' - 10"
DISP: 9500 lbs
BALLAST: 3300 lbs
D/L: 343
SAIL AREA: 466 sq. ft.

The Trip

View Katla

Monday 1 August 2011

Whales Azores - UK

A small piece of film showing the Whales that followed me for a few days while enroute from the Azores to the UK.